Monitoring switches and firewall

Share your story of how you use NEMS Linux. Provide as much detail as you can, and even pictures and screenshots for your chance to get featured in various publications (and of course, here on the forum)!
Post Reply
Junior Member
Posts: 1
Joined: Fri May 08, 2020 9:56 pm

Monitoring switches and firewall

Post by rudym88 »

Good day,

Hoping someone can guide me. I am a complete n00bie,i thing my needs are fairly basic but don't seem to be able to figure out how to doing.

I have 4 Netgear 48 port PoE switched and a TZ350 sonicwall. I would like to be able to monitor the following on each of these devices.

Immediate needs
1- the bandwidth on each ports and if it goes over 50% to alert me
2- is switch does offline
3- if one of the ports goes offline
1- Internet speed, receive an alert if speed is over 50%
2- ping a remote site

In the future
1- monitor Hyper-V host and guest
2- monitor the speed of the nic on all workstation
3- monitor toner on HP laset printer

any help and guldens is greatly appreciated.


Post Reply