NEMS Linux Community Forum

Hi,

I'm new to NEMS, though i've been working with nagios some years ago. So i installed NEMS on a raspberry pi 3 today.

Installation and initialization went fine so far I believe, but when I try to access the web ui (https://nems.local or ip address) it only shows me a blank page.

I've tried different browsers but all behave alike.
I'm only getting the 'your connection is not safe' message but after adding the url to my exception list nothing shows up.
Completely white page.

I've read this could be due to a time mismatch between NEMS and my machine, so I checked this but both clocks are in sync.

I'm at home right now so I can't tell the exact NEMS version, I believe it was 1.5.2 or 1.5.3 - not sure, but it said it would be up to date.

I repeated nems-init, still same issue.
Console login is working fine.

Where should I start troubleshooting this issue?
Any advice is greatly appreciated.

Thank you all in advance,
Chris

Looks like my SD-Card was corrupted, I just re-flashed the Image and ran another initialization, now everything is fine.
Thx for reading, problem solved!